Test Kit Instructions:
A Copper Test Kit is needed to maintain the proper level of Bacteriacide/Algaecide.
Follow startup instructions in this guide adding the appropriate amount of Bacteriacide/Algaecide. Take the sample 12-18" below the surface, following instructions in the test kit
NOTE: If you apply the Bacteriacide/Algaecide at the proper rate of 1.0 PPM and you do not obtain this reading you are either not reading the test correctly or there may be something in your water that causes the test to read inaccurately. If you are obtaining a very low reading after applying the correct amount do not add more and over dose the water. Continue to use the product at the recommended amounts in the Treatment Guide.
For Your Information:
The information contained in this User's Guide is, to the best of our knowledge, reliable and accurate. Suggestions contained herein are the opinion of Pacific Sands/Environ. You should determine for yourself whether these products are suitable for your application and objectives.
Pacific Sands, Inc. and Environ Intercontinental, LTD. makes no guarantee of satisfactory results from reliance upon this Guide and disclaims any liability for any resulting loss or damage. This information is not intended to supercede or conflict with federal, state, or local statues or regulations.
Save BIG on algae-free pool for next spring: www.ecoONE.biz Coupon Code: CSRFB
